Opsis Dashcam 1954024 & 1954025: Dashcam reboots

When the dashcam powers on, if it immediately reboots, this may be due to the rear camera USB not being fully plugged in.

1. Unplug all connections from the dashcam.
2. Unplug the rear camera and then plug it back in firmly, ensuring that the camera is plugged in all the way. This is most likely the cause of the problem.
3. Plug the rear camera cable back into the dashcam, and as with the rear camera, make sure it is plugged in all the way.
4. Plug the power connector back into the dashcam and then start the vehicle.
5. After the camera powers up, press the reset button on the side of the dashcam with a paper clip.
6. After the dashcam loads back up, the problem should be resolved.